HVAC Repair in Queens, NY
Homes here need heat from October through April and cooling from June through September. If your system quits, tell us what it's doing and a licensed contractor who covers Queens County will get in touch.
Tell us about the job
It takes about a minute.
Eleven months of work a year, on a system that only gets four off
Queens homes only get a real break from the system in spring and fall. Heat runs October through April, seven months, and on nights that average 28°F the furnace cycles on and off for hours to hold the house steady. Every start puts load on the igniter and the burner. Come June the same system switches to cooling and runs afternoons averaging 83°F clear through September.
That kind of year round use catches up with parts eventually, and storms make it worse. Queens has seen 33 winter storms and 116 damaging wind events over the past ten years, and statewide, 11% of households lost power for a day or more in 2024 alone. A furnace or AC that comes back on hard after an outage is more likely to show whatever weakness was already there.
- 7 months
- October through April, your system heats
- 4 months
- June through September, it cools
- 28°F
- the average winter night it heats against
- 83°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
A new furnace and air conditioner would cut about $160 a year off heating and cooling for a typical Queens County home.
Estimates for a typical Queens County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, New York fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed.
Replacement makes sense when the furnace's heat exchanger is cracked, the air conditioner's compressor has failed, or repairs keep coming.
- Why is my heat not working?
- Start with the thermostat. Make sure it is set to heat and the temperature is set above room temperature, since a setting bumped a degree or two can look like a dead system. If the thermostat is fine, check the power switch on the furnace itself and the breaker it runs on. A furnace that won't start at all is often a tripped breaker, a switch that got bumped off, or a pilot light or igniter that failed. With winter nights here averaging 28°F, a furnace that stays off for even a few hours is worth calling in fast.
- Why is my system running but not cooling the house?
- Check the air filter first. A filter clogged with dust blocks airflow across the coil, and when that happens the coil can ice over and stop cooling the air even though the system is running. Check that all your supply vents are open and unblocked by furniture or curtains. If the filter is clean and the vents are clear, the system may be low on refrigerant or have a failing part, and that needs a contractor to diagnose.
- What can I check before calling for HVAC repair?
- Check the thermostat settings, the batteries in it if it uses any, and the breaker for the system. Check the air filter and replace it if it looks gray or clogged, since a blocked filter causes both heating and cooling problems. For a furnace, look for a power switch that may have been switched off by accident. If the outdoor unit or a vent hood is covered in snow, ice, or debris, clearing it can also solve the problem. If none of that changes anything, a contractor will need to look at it directly.