HVAC Installation in Bronx, NY
A new system here will heat from October through April and cool from June through September every year. Tell us about the house, and a licensed contractor who covers Bronx County will get in touch.
Tell us about the job
It takes about a minute.
Bronx winters and summers both ask a lot of a new system
Your heating system in the Bronx works October through April, seven months of the year. Winter nights average 28°F through those months, cold enough that a furnace or heat pump has to run long hours to keep the house warm. Summer afternoons average 83°F, and the system switches to cooling duty from June through September. Eleven months out of the year, a system here is doing one job or the other.
A system sized wrong for that shows up fast. Too small, and it runs constantly in the cold and still falls behind in the heat. Too large, and it cycles on and off without pulling the damp out of the summer air. Just over half of homes in New York heat with gas, and whatever fuel yours uses, the installer needs to size the system to your house, not just to the weather outside it.
- 7 months
- October through April, your system heats
- 4 months
- June through September, it cools
- 28°F
- the average winter night it heats against
- 83°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
- When should I replace my HVAC system?
- Replace your system once repairs start costing close to what a new unit would run, or when it can no longer keep up on the coldest or hottest days. Rising energy bills, uneven heating between rooms, and a furnace or air conditioner that runs longer than it used to are signs the equipment is wearing out. Homes here need heat from October through April and cooling from June through September, so a breakdown can leave you without one or the other for months. A contractor can look at the age and condition of your system and tell you whether repair still makes sense.
- Should I replace my furnace and air conditioner at the same time?
- If both are near the end of their life, replacing them together makes sense. A furnace and air conditioner installed at different times can end up mismatched, which strains the newer unit and can shorten its life. They also share the same ductwork and often the same air handler, so working on both at once means one disruption instead of two. If one unit is much newer than the other, a contractor can tell you whether it has enough life left to wait.
- What happens during an HVAC installation?
- A contractor first removes the old furnace, air conditioner, or both, along with any parts that will not be reused. The new equipment goes in, then gets connected to your ductwork, gas line or electrical circuit, and refrigerant lines. After that, the contractor tests the system, checks airflow and refrigerant charge, and walks you through the thermostat and any new controls. The exact steps depend on what is being replaced and the layout of your home, so a contractor can walk you through what your job will involve.