HVAC Installation in Niagara Falls, NY
A new system here will heat from October through May and cool from July through August every year. Tell us about the house, and a licensed contractor who covers Niagara County will get in touch.
Tell us about the job
It takes about a minute.
Ten months of the year, your system is working
Winter nights average 21°F here from December through February, and homes need heat from October through May. That is eight months of the year the furnace has to keep up. Summers are shorter but real too, with afternoons averaging 79°F in July and August when the air conditioner has to carry the house.
A new system here has to handle both ends of that. Most homes in the area heat with gas, so the furnace is doing the heavy lifting most of the year, while the air conditioner only gets two months of work. Any new installation has to be sized for a long, cold heating season and a short, hot cooling season, not just one or the other.
- 8 months
- October through May, your system heats
- 2 months
- July through August, it cools
- 21°F
- the average winter night it heats against
- 79°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
- When should I replace my HVAC system?
- Replace it when repairs get frequent, when it can no longer keep the house warm, or when it's old enough that parts are getting harder to find. A furnace that short cycles, makes new noises, or needs a repair every year is telling you it's done. Your furnace runs from October through May here, eight months of real use every year, so an aging system gets tested hard for most of the year. If yours is struggling now, waiting for it to fail completely means going without heat during those cold months.
- Should I replace my furnace and air conditioner at the same time?
- If both are old, yes, because they're usually matched to work together and replacing only one can leave the other running poorly. A furnace and coil installed as a pair are sized for each other. Put a new furnace under an old air conditioner and the mismatch can shorten the life of both. If one unit is much newer than the other, a contractor can look at your setup and tell you whether replacing just the failed one makes sense.
- What happens during an HVAC installation?
- A contractor removes the old equipment and sets the new furnace or air conditioner in place. It gets connected to your ductwork, to the gas line or refrigerant lines, and to the electrical. Then comes testing, gas pressure, airflow, refrigerant charge, and the thermostat and safety controls all checked to make sure they work together. A contractor walking through your specific home can tell you what the job will involve and how long it will take.